connectors
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- haldcohen
- Posts: 2
- Joined: Thu Jun 29, 2017 1:11 pm
connectors
What is the female connector that will fit on the "wire spikes" on the ramps board? I need to attach the bare wires of the stepper motor to the board. Is it the JST connector?
- adafruit_support_mike
- Posts: 67454
- Joined: Thu Feb 11, 2010 2:51 pm
Re: connectors
Could you post a link to the product you're thinking about please?
- haldcohen
- Posts: 2
- Joined: Thu Jun 29, 2017 1:11 pm
Re: connectors
RAMPS 1.4 REPRAP 3D PRINTER CONTROLLER
- adafruit_support_mike
- Posts: 67454
- Joined: Thu Feb 11, 2010 2:51 pm
Re: connectors
I don't think we carry that one, but from what I see in the photos on this page:
http://reprap.org/wiki/RAMPS_1.4
Most of the connectors are either male or female pin header. If you're looking for a connector to work with the male pin header, we have these:
https://www.adafruit.com/category/306
The general term for them is '0.1"/2.54mm rectangular wire connector'.
http://reprap.org/wiki/RAMPS_1.4
Most of the connectors are either male or female pin header. If you're looking for a connector to work with the male pin header, we have these:
https://www.adafruit.com/category/306
The general term for them is '0.1"/2.54mm rectangular wire connector'.
Please be positive and constructive with your questions and comments.