0

connectors
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

connectors

by haldcohen on Thu Jun 29, 2017 1:18 pm

What is the female connector that will fit on the "wire spikes" on the ramps board? I need to attach the bare wires of the stepper motor to the board. Is it the JST connector?

haldcohen
 
Posts: 2
Joined: Thu Jun 29, 2017 1:11 pm

Re: connectors

by adafruit_support_mike on Thu Jun 29, 2017 11:03 pm

Could you post a link to the product you're thinking about please?

adafruit_support_mike
 
Posts: 44188
Joined: Thu Feb 11, 2010 2:51 pm

Re: connectors

by haldcohen on Fri Jun 30, 2017 1:13 pm

RAMPS 1.4 REPRAP 3D PRINTER CONTROLLER

haldcohen
 
Posts: 2
Joined: Thu Jun 29, 2017 1:11 pm

Re: connectors

by adafruit_support_mike on Fri Jun 30, 2017 11:39 pm

I don't think we carry that one, but from what I see in the photos on this page:

http://reprap.org/wiki/RAMPS_1.4

Most of the connectors are either male or female pin header. If you're looking for a connector to work with the male pin header, we have these:

https://www.adafruit.com/category/306

The general term for them is '0.1"/2.54mm rectangular wire connector'.

adafruit_support_mike
 
Posts: 44188
Joined: Thu Feb 11, 2010 2:51 pm

Please be positive and constructive with your questions and comments.