Custom CP2104 PCB Not working
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- kowshik1729
- Posts: 2
- Joined: Wed Jun 27, 2018 1:20 pm
Custom CP2104 PCB Not working
I have made a custom PCB using ESP32-Wroom 32 SoC. I have used a CP2104 USB-UART bridge to program the SoC. But when I connect my board into the computer it is not getting recognized and the says an error like "Device Descriptor request failed" . I had searched a lot regarding this and I can't find anything on this. I have attached my schematics below, I don't think so there are any wrongs with my schematics. The entire board is getting powered up correctly but CP2104 is not getting recognized.
I've been knocking my head since a week on this issue. Please help me out.
- jps2000
- Posts: 811
- Joined: Fri Jun 02, 2017 4:12 pm
Re: Custom CP2104 PCB Not working
May be you have crossed DP and DN on the USB conn? The symbol seems faulty. Check it physically on the board
- kowshik1729
- Posts: 2
- Joined: Wed Jun 27, 2018 1:20 pm
Re: Custom CP2104 PCB Not working
jps2000 wrote:May be you have crossed DP and DN on the USB conn? The symbol seems faulty. Check it physically on the board
Yeah many people has questioned me this. So, what I did is, ripped the USB cable I'm using, reversed the D+ and D- pins and no luck then too. Is there any fault with my CP2104 schematic?
Please be positive and constructive with your questions and comments.