where can i find a kit or open design and cut tape parts list to test my pick and place?
I have a madell mini x1 pick n place with solder paste extruder and want to test out my process and I am using the arduino reflow oven controller shield.
I am using lead free solder paste.
where can i find a kit or open design and cut tape parts lis
Moderators: adafruit_support_bill, adafruit
2 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.
- josheeg
- Posts: 213
- Joined: Wed Jan 16, 2008 8:38 am
Re: where can i find a kit or open design and cut tape parts
Start with some basic grids and angular layouts. Make 10x10 grids of 10k 0805 resistors (or whatever is cheap), then lay out circles with the resistors arranged radially. Change the spacing to see how tight you can pack them.
-
adafruit_support_mike - Posts: 61107
- Joined: Thu Feb 11, 2010 2:51 pm
2 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.