Hi after lot of delay and issue new tow was finally here ;-)
i let you guess what it is , but it 11 x 7 feet and weight 4,000LBS and cost lot of money
so the machine was a quite recent MY9e full equip ,Midas / Hydra / Linescan / DVS and Runing TPsys 2.8
it twin sister whit 1 digit difference on serial number was listed on ebay it come from same production plant that were i buy my http://www.ebay.com/itm/MyData-Mycronic ... 1454868910
please note i not associated whit this seller ,i only knot that it buy the second machine after i buy the first one ..
and knot that both machine was identical and maintained under contract by mydata until plant closure last July
First some key fact and answer to question i have like to knot before have machine here1-) power requirement
Mydata manual said Delta connection whit neutral and earth so 5 wire
it even specify neutral to phase and phase to phase voltage as example 215/125V ,if you ask electrician about that it will puzzled and that make me lot of head headache , Delta was 3 wire + safety earth so no neutral ,have investigate the power plug on the machine , NEUTRAL WAS NOT USED
so it plain normal delta
this is how i connect it to plain 2 phase 240V service
240V 40A 2 phase ---> Q1C5ESCF Hammond Transformer ( 240v to 208V) ----> NAPCES PL-10 Pro-Line 10HP Rotary Phase Converter --->Disconect SW --> Machine 2-) Required door opening
absolute minimum was 48" i recommend 50 and up "
you need to remove front and back hood and the Y table module this take ~ 60 minute , table module weight 300-400 LBS so 4 guy need
if you have 48" you need to remove the X motor to ,good luck .....
if you have 50" only need to remove the X motor encoder and the black bell were encoder was fixed ,it take less that 5 minute 3-) moving the machine
one good option was BD3310PW Bond Dolly with Phenolic Wheels Ebay http://www.ebay.com/itm/-/111663357886
ok it overload whit that machine ,but it do the job even if abused
other option was use tread under machine frame for both wheel set ,tread was M9 x 1.25 and top plate was 10.5cm x 8cm i not find supplier for this 4-) if remove the Y table don't leave screw on it hole ,if table move linear encoder will hit the screw top ,learned it hard way
more to come ....