Does anyone have a photo of the Tiny-G board installed in the base of their Othermill. I had to replace mine and the photo that I took to show me where everything connected was cut off on the right (output) side. Naturally I didn't notice that until I had disconnected everything. No need to worry... I had a photo... not...
I need to know where the white connecters with color coded wiring bundle markers land. Colors are Red, Green, and Blue. Choices are Motor 1, Motor 2, Motor 3, and Motor 4. 4 outputs... 3 motors... Guessing would be unhealthy for my mill and unwise.