Hi,
first post for me here, sorry if I am posting in the wrong forum!
I have purchased a Small Reduction Stepper Motor (this one: https://www.adafruit.com/product/858) but I am looking for a hub to mount, because that rectangular "head" is not very practical.
I was able to find only this hub that looks compatible:
Snap-on Hub for TT Motor
https://www.adafruit.com/product/3769
Can you please confirm that I can mount that hub on the stepper?
Or could you please link me to hubs to buy for the stepper?
Thank you in advance!
Snap-on Hub for TT Motor question
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_mike
- Posts: 67446
- Joined: Thu Feb 11, 2010 2:51 pm
Re: Snap-on Hub for TT Motor question
I'm afraid they won't fit together as-is.
The TT hub's slot is 5.4mm x 3.7mm, while the stepper's shaft is 5mm x 3mm. You could fill the space with hot-melt, or something similar, but they don't snap-fit.
The stepper is designed for 5mm shaft hardware with grub screws:
https://www.adafruit.com/product/1175
https://www.adafruit.com/product/1251
The TT hub's slot is 5.4mm x 3.7mm, while the stepper's shaft is 5mm x 3mm. You could fill the space with hot-melt, or something similar, but they don't snap-fit.
The stepper is designed for 5mm shaft hardware with grub screws:
https://www.adafruit.com/product/1175
https://www.adafruit.com/product/1251
Please be positive and constructive with your questions and comments.