I ordered an ES120 on June 14th, and when I got the screwdriver, it worked fine, until I tried it on a very loose screw. Now it keeps cutting out, even with the new firmware. I believe the issue is caused by the battery not being able to supply enough current, and tripping the overcurrent protection, so basically it is a design fault.
This product does not seem to be of the same impeccable quality of every single other Adafruit product I have ever had.
I would like to request a return and refund.
ES120 Failure
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Machman
- Posts: 11
- Joined: Tue Nov 28, 2017 12:59 am
Re: ES120 Failure
I have emailed Morningstar tools, they requested a video of the problem and a receipt, and I will be sending that over to them. I would like to resolve this issue, preferably to get a return and refund.
- adafruit2
- Posts: 22194
- Joined: Fri Mar 11, 2005 7:36 pm
Re: ES120 Failure
hi did this get resolved?
- Machman
- Posts: 11
- Joined: Tue Nov 28, 2017 12:59 am
Re: ES120 Failure
Yes, had to go through email
Please be positive and constructive with your questions and comments.