Hi Everyone,
for my thesis project I have to heat a plastic panel. Now I'm using a Nickel-Chrome wire (resistivity=60 ohm/sq, Nominal Temperature Coefficient of Resistance: 0.00011 Ω/Ω/°C ) but I would to replace it with a ITO coated PET panel with resistivity=50 ohm. Unlikely on Adafruit site is not written its Nominal Temperature Coefficient of Resistance, so I cannot know if it is suitable for my purpose. Where can I get this information related specifically on the item sold on Adafruit site?
Thanks in advance
Giovanni
ITO Coated Pet panel
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_carter
- Posts: 29168
- Joined: Tue Nov 29, 2016 2:45 pm
Re: ITO Coated Pet panel
Please try not cross post.
viewtopic.php?f=19&t=122469
viewtopic.php?f=19&t=122469
Please be positive and constructive with your questions and comments.