๐Ÿ“ฃ๐Ÿ“ช ๐Ÿšš Adafruit will not be shipping USPS orders Monday October 14, 2019 ๐Ÿ—“. Expedited USPS orders placed after 11am ET ๐Ÿ•š Friday October 11 will go out Tuesday October 15 ๐Ÿ“ฃ๐Ÿ“ช๐Ÿšš
0

GPS for scanner
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

GPS for scanner

by bk0 on Wed Jun 14, 2017 12:00 pm

Will this little GPS module work with the Uniden BCD436HP Scanner?
https://learn.adafruit.com/adafruit-ultimate-gps

I can get 3.7V off the main board and just solder the TX/RX/GND directly to the USB input pins on the board.

bk0
 
Posts: 2
Joined: Wed Jun 14, 2017 10:46 am

Re: GPS for scanner

by bk0 on Wed Jun 14, 2017 3:02 pm

The inputs are not USB, they are serial, it just happens to use a funky non standard 4 pin USB plug.

Please see this for ref: http://forums.radioreference.com/uniden ... nners.html

bk0
 
Posts: 2
Joined: Wed Jun 14, 2017 10:46 am

Re: GPS for scanner

by franklin97355 on Wed Jun 14, 2017 10:50 pm

Don't see why it wouldn't work. You could use 5 volt power if you wanted to.

franklin97355
 
Posts: 21204
Joined: Mon Apr 21, 2008 2:33 pm
Location: Lacomb, OR.

Please be positive and constructive with your questions and comments.