Will this little GPS module work with the Uniden BCD436HP Scanner?
https://learn.adafruit.com/adafruit-ultimate-gps
I can get 3.7V off the main board and just solder the TX/RX/GND directly to the USB input pins on the board.
GPS for scanner
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- bk0
- Posts: 2
- Joined: Wed Jun 14, 2017 10:46 am
Re: GPS for scanner
The inputs are not USB, they are serial, it just happens to use a funky non standard 4 pin USB plug.
Please see this for ref: http://forums.radioreference.com/uniden ... nners.html
Please see this for ref: http://forums.radioreference.com/uniden ... nners.html
- Franklin97355
- Posts: 23910
- Joined: Mon Apr 21, 2008 2:33 pm
Re: GPS for scanner
Don't see why it wouldn't work. You could use 5 volt power if you wanted to.
Please be positive and constructive with your questions and comments.