0

3x4 Right Angle Male Header - 4 pack PRODUCT ID: 816
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

3x4 Right Angle Male Header - 4 pack PRODUCT ID: 816

by agarza5724 on Fri Jul 07, 2017 6:33 pm

rightangle.jpg
picture
rightangle.jpg (255.3 KiB) Viewed 218 times


i can't say i'm very happy at the moment, but an inconvenience for sure. these pins are a hair too short to make contact with the wire, and a little too long at the bottom.

[img]
https://www.dropbox.com/s/xjh2m35o9eo3x ... 4.jpg?dl=0
[/img]

i intend RC application for this and i need to make sure these fit well

agarza5724
 
Posts: 3
Joined: Fri Jul 07, 2017 6:13 pm

Re: 3x4 Right Angle Male Header - 4 pack PRODUCT ID: 816

by adafruit_support_bill on Fri Jul 07, 2017 6:37 pm

Connectors attach to the other end. Those pins are what get soldered to the board.

adafruit_support_bill
 
Posts: 73049
Joined: Sat Feb 07, 2009 10:11 am

Re: 3x4 Right Angle Male Header - 4 pack PRODUCT ID: 816

by agarza5724 on Fri Jul 07, 2017 6:51 pm

can you post a picture please, of how it is properly soldered?

agarza5724
 
Posts: 3
Joined: Fri Jul 07, 2017 6:13 pm

Re: 3x4 Right Angle Male Header - 4 pack PRODUCT ID: 816

by adafruit_support_bill on Fri Jul 07, 2017 7:16 pm

This is how they would be soldered on the 16 channel PWM/Servo breakout:
Image

adafruit_support_bill
 
Posts: 73049
Joined: Sat Feb 07, 2009 10:11 am

Please be positive and constructive with your questions and comments.