Adafruit 2.8" TFT with capacitive touch

[ParasN]

Hi

I bought a tft shield(original) a few days back. It was working well with my Arduino uno. Later, I shifted to Arduino mega. I soldered and cut the pins as per the instructions on the official pages of Adafruit. It worked well for a couple of days but then all of a sudden it stopped working and all it shows now is a blank white screen. I have no idea what has gone wrong with it.

I’m attaching the pictures of the tft.

I wish I could get some help to get it back in working condition.

Thanks.

[thenzero]

This might sound dumb, but have you tried hitting reset after plugging it in? That's what works for me...

[ParasN]

Yes I did. Several times in fact. But it did no good.

[adafruit_support_bill]

Thank you for the clear photos. Your soldering and cut traces look fine. I think this is just a case of premature failure. Please contact [email protected] with a link to this thread for a replacement.

[ParasN]

Sure. Thank you so much for your support!