Mounting NeoTrellis to front panel

EL Wire/Tape/Panels, LEDs, pixels and strips, LCDs and TFTs, etc products from Adafruit

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Post Reply
User avatar
bill_fisher
 
Posts: 1
Joined: Sat Aug 13, 2022 8:26 am

Mounting NeoTrellis to front panel

Post by bill_fisher »

I’m looking for info on mounting a single 4x4 NeoTrellis to a front panel. I see four very small holes that pass through the PCB and elastomer buttons. Are these the best way to mount the NeoTrellis to a front panel? Or should I try to make new holes in the elastomer and use the larger holes in the PCB?

Does anyone know what size of screw will work in any of these holes? I did try M3 in the larger holes, and M3 is too big.

I’m only interested in mounting to the front panel, not sandwich designs like this: https://learn.adafruit.com/neotrellis-s ... l-assembly

Thanks in advance!

User avatar
adafruit_support_mike
 
Posts: 65255
Joined: Thu Feb 11, 2010 2:51 pm

Re: Mounting NeoTrellis to front panel

Post by adafruit_support_mike »

The holes in the corners should work for you.

The hole diameter is 0.100".. M2.5 or #4 screws should work.

Post Reply
Please be positive and constructive with your questions and comments.

Return to “Glowy things (LCD, LED, TFT, EL) purchased at Adafruit”