I posted this a couple of weeks ago but it must've gotten lost..
My SSD1306 worked wonderfully until I did a reboot. Now it only displays noise.
Even if I run the demos it will always display the exact same pattern. So far, I've tried a reboot, a shut down, and a shut down and left the display unplugged for a length of time but to no effect.
I'm open for ideas and suggestions.
Could use some help with SSD1306
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Krang
- Posts: 11
- Joined: Thu Aug 09, 2012 2:43 pm
Could use some help with SSD1306
- Attachments
-
- file.jpg (142.06 KiB) Viewed 258 times
- Franklin97355
- Posts: 23911
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Could use some help with SSD1306
Flip it over and post a picture of that side.
- Krang
- Posts: 11
- Joined: Thu Aug 09, 2012 2:43 pm
Re: Could use some help with SSD1306
Thanks for the reply. Here's the back.
- Attachments
-
- 2017-03-19-11-30-47-3.jpg (297.68 KiB) Viewed 219 times
- Franklin97355
- Posts: 23911
- Joined: Mon Apr 21, 2008 2:33 pm
Re: Could use some help with SSD1306
I don't see anything wrong there. Please contact [email protected] with a link to this topic and they will help you get a replacement PID938 display.
- Krang
- Posts: 11
- Joined: Thu Aug 09, 2012 2:43 pm
Re: Could use some help with SSD1306
Aw bummer. Thanks for the help!
Please be positive and constructive with your questions and comments.