Help With Connecting OLED to GPIO with additional components

[merdle344]

Hi,

I am wondering if anyone can help me out? I would like to know if it is possible to stack an "Adafruit PiOLED - 128x32 Monochrome OLED Add-on" on a "Pimoroni LiPo SHIM" with an "RPI0" as a base? Or do I need to use a perf board for them to function together properly? The links for each product are below. Thank you in advance for your help. I am new with all of this, so any information will be great!!

Products Purchased:
https://www.adafruit.com/product/3708 - Raspberry Pi Zero WH

https://www.adafruit.com/product/3196 - Pimoroni LiPo SHIM

https://www.adafruit.com/product/3527 - Adafruit PiOLED - 128x32 Monochrome OLED Add-on

Possible perf/breadboard option:
https://www.adafruit.com/product/3203

LiPo SHIM pinout:
https://pinout.xyz/pinout/zero_lipo

PiOLED pinout:
https://pinout.xyz/pinout/pioled

[purchasemail]

I was looking into this, but the link for the Pi Power Shim is not correct. It shows IO for RasPI, not the shim.
.
Does anyone have the correct pinouts for the shim (adafruit 3196, pimoroni PIM185)?