0

RGB Matrix 32x32 with HAT
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

RGB Matrix 32x32 with HAT

by kevcrit on Sat Mar 10, 2018 12:05 pm

Hi,

I have assembled the HAT and Matrix correctly to the best of my knowledge by the demos just light up rectangles of blue LEDs (half half of the display) and sometimes lines. I read something about the clocking speed of my Rpi but I can't change this in my config (RPi 3). I am a bit frustrated because I have spent out quite a bit on this kit and its not working. Any suggestions would be good! Do I have a defective HAT or Matrix?

kevcrit
 
Posts: 1
Joined: Sat Mar 10, 2018 11:57 am

Please be positive and constructive with your questions and comments.