3B+ & 3.5" Plus and Octoprint issues

EL Wire/Tape/Panels, LEDs, pixels and strips, LCDs and TFTs, etc products from Adafruit

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
ExplodedZombie
 
Posts: 3
Joined: Mon Apr 16, 2018 9:06 pm

3B+ & 3.5" Plus and Octoprint issues

Post by ExplodedZombie »

Hello,

I recently purchased a Raspberry Pi 3B+ and 3.5" Plus. I attempted to follow the instructions for getting Octoprint onto the Jessie-based Raspbian but things didn't turn out well. When I finally got the desktop loading, icons were all smooshed together. I finally had to give up, load the Octoprint from the official site (nightly build) and leave the TFT off.

Has anyone successfully gotten these things working? All tutorials I could find dealt with older hardware.

Thanks!

Locked
Please be positive and constructive with your questions and comments.

Return to “Glowy things (LCD, LED, TFT, EL) purchased at Adafruit”