1. It the associated product description, it says
.This board/chip uses I2C 7-bit address between 0x3C-0x3D, selectable with jumpers
2. In the associated tutorial, it says
.To start, you'll need to solder the two jumpers on the back of the OLED. Both must be soldered 'closed' for I2C to work!
I'm sitting here preparing for a group of students and I just cannot find the jumpers that allows selecting one of the two aforementioned I2C addresses. Is the product description faulty?
Thank you very much in advance for how we can change the I2C address!