0

1.54" OLED Slow Update
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

1.54" OLED Slow Update

by ilikecake on Sat Dec 21, 2019 12:38 am

Hi,

I have purchased one of these. I have attached it over SPI to a Raspberry Pi Zero W. My plan is to use the display to show temperature and pressure measured from a remote sensor. I have followed the tutorial and gotten the test code working on python. I have the code set to run once a minute and update the display with the current measured pressure and temperature. The code updates the screen the way I expect, but there is an approximately half second where the screen blanks before updating.

Is this expected behavior? I was expecting the refresh would not be noticeable.

ilikecake
 
Posts: 1
Joined: Thu Dec 19, 2019 12:30 am

Please be positive and constructive with your questions and comments.