Troulbe calibrating 7" HDMI touchscreen

EL Wire/Tape/Panels, LEDs, pixels and strips, LCDs and TFTs, etc products from Adafruit

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
djgruver
 
Posts: 3
Joined: Fri Mar 30, 2018 11:20 pm

Troulbe calibrating 7" HDMI touchscreen

Post by djgruver »

I have the 7" HDMI touchscreen with e backpack and AR1100 chip. The calibration is off, as I cannot target the top of the screen.

I followed the steps here to calibrate (https://learn.adafruit.com/ar1100-resis ... ation-2-23) .

I was able to download the software, and start the calibration tool. But I keep getting communication errors. I am connected via USB. When I plug in the device, it is recognized in the transaction console in the Microchip AR configuration utility. But whenever I try to run the calibration routine, it throws an error and does not go into calibration mode. Any help of thought appreciated.

User avatar
mikeysklar
 
Posts: 13824
Joined: Mon Aug 01, 2016 8:10 pm

Re: Troulbe calibrating 7" HDMI touchscreen

Post by mikeysklar »

Are you calibrating as a primary or secondary monitor?

Have you tried skipping the calibration and going into expert mode? Then selectino Options Ar1100 Mouse and Verify Communication.

https://learn.adafruit.com/ar1100-resis ... guide/help

Locked
Please be positive and constructive with your questions and comments.

Return to “Glowy things (LCD, LED, TFT, EL) purchased at Adafruit”