Hi there I recently received the 1.8" TFT LCD w/ SD breakout, and when I wire it up, the backlight comes, on, the serial monitor runs through its thing(init -> time -> done) and none of digital pins on the board are dead. Am I doing something wrong or is my LCD defective? I've tried wiring it with both flexible and high-speed wiring.
I have essentially the same problem noted here:http://forums.adafruit.com/viewtopic.php?f=47&t=25629
Attached is the wiring I'm using. I have the green-tabbed LCD, and I made sure the red_init was commented out.
Do I need a new one or am I missing something obvious?
Ach, sorry for the photo sizes
1.8 inch TFT LCD w/ SD breakout doesnt seem to be working
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
-
- Posts: 3
- Joined: Wed Nov 16, 2011 2:05 am
1.8 inch TFT LCD w/ SD breakout doesnt seem to be working
- Attachments
-
- WP_000048.jpg (282.81 KiB) Viewed 1083 times
-
- WP_000046.jpg (351.98 KiB) Viewed 1083 times
- adafruit_support_bill
- Posts: 88087
- Joined: Sat Feb 07, 2009 10:11 am
Re: 1.8 inch TFT LCD w/ SD breakout doesnt seem to be working
Looks like your header is not soldered to the breakout board. You need to solder it to assure good connections.
Please be positive and constructive with your questions and comments.