Voting resources, early voting, and poll worker information - VOTE. ... Adafruit is open and shipping.
0

PROBLEMS WITH BNO055 SHUTTLE BOARD CALIBRATION
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

PROBLEMS WITH BNO055 SHUTTLE BOARD CALIBRATION

by FranciscoCTorres on Mon May 11, 2020 3:06 pm

Hi!
After following all the steps to complete the calibration of the BNO055 sensor (https://learn.adafruit.com/bno055-absol ... alibration) and despite not having a problem while I was in the Orientation Demo, when I ran the script that I found in one of this Adafruit's tutorials, only the Gyroscope was fully calibrated. I don't know if I need to set the calibration parameters before using the get_calibration_status( ) function.

I've already try to look up in the BNO055.py file, to see if I could understand the error that I'm making while looking to the definition of the functions, but I cannot understand the problem.

If any of you could help me, I would be very thankful.

FranciscoCTorres
 
Posts: 1
Joined: Mon May 11, 2020 2:52 pm

Please be positive and constructive with your questions and comments.