Dear all,
Hi again. I've been working through all the Adafruit tutorials I can find relating to the sensors on my Feather Sense (https://www.adafruit.com/product/4516). With that experience in hand, I have a couple questions.
The Adafruit articles on magnetometer and gyroscope calibration (https://learn.adafruit.com/adafruit-sen ... alibration and https://learn.adafruit.com/adafruit-sen ... alibration ) show how to derive calibration values, but don’t give examples or point to examples of code that implement these values. Given the calibration values, a newbie would want to use them, test them; but testing/using isn't described/shown. Or am I missing something there?
My guess is to use the write_callibration sketch shown in the AHRS tutorial (https://learn.adafruit.com/how-to-fuse- ... -pre-check) to add gyroscope calibration data. Is that correct and/or could I get another example of how do incorporate the calibration values?
Thanks much for any help, suggestions, and/or ideas,
Doug
Motion sensor calibration and usage
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- sipan1313
- Posts: 18
- Joined: Sun Jan 30, 2022 4:37 pm
Re: Motion sensor calibration and usage
it was a qreat post... thank you
Please be positive and constructive with your questions and comments.