๐Ÿ“ฃ๐Ÿ“ช ๐Ÿšš Adafruit will not be shipping USPS orders Monday October 14, 2019 ๐Ÿ—“. Expedited USPS orders placed after 11am ET ๐Ÿ•š Friday October 11 will go out Tuesday October 15 ๐Ÿ“ฃ๐Ÿ“ช๐Ÿšš
0

MintyMp3 V2 with usb - when to program microcontroller
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

MintyMp3 V2 with usb - when to program microcontroller

by TheMaximumweasel on Tue Jan 03, 2006 2:19 pm

ok so I have all of the parts but on the fabrication instructions it says you can load code to the microcontroller from usb does that mean I can put all of the parts on then upload the bootloader and all of that or do I program it with the first instructions to get all 5 wires on a DIP socket and program from there.


Max
TheMaximumweasel
 

by TheMaximumweasel on Tue Jan 03, 2006 2:21 pm

Just incase I wasn't clear basically with version 2 can I just do all programming through usb instead of making the dongle with just the microcontroller on the board.


Max
TheMaximumweasel
 

by Student on Wed Jan 04, 2006 2:59 am

No, you have to program the microcontroller with the dongle and all that before anything else. This allows you to later program the microcontroller through the USB port with the rest of the firmware.
Student
 
Posts: 45
Joined: Tue Apr 12, 2005 4:40 am
Location: CA

Please be positive and constructive with your questions and comments.


cron