Hi,
I purchased a PowerSwitch Tail II some time ago but am just not getting to use it, but I am confused as to how to use it. I have a RPi 3 and I just want the PST to kick on when the RPi is on and off when the RPi is off. What pins on the RPi would I need to connect to the PST to accomplish this? I don't know anything about writing code so I was hoping there was just some pins that would be on/off depending on the RPi state to control the PST state. I'm just want to use it to kick a monitor on automatically when the RPi is on and then off when the RPi is off.
Thanks.
POWERSWITCH TAIL II
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- adafruit_support_mike
- Posts: 67454
- Joined: Thu Feb 11, 2010 2:51 pm
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/