Due to high demand expect some shipping delays at this time, orders may not ship for 3-4 business days. On MLK Day no orders will be shipped.

Enviro & PMS5003 Part Sensor
Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Please be positive and constructive with your questions and comments.

Enviro & PMS5003 Part Sensor

by worbc on Sun Nov 28, 2021 11:55 pm

I mistakenly purchased the four Enviro instead of the Enviro+ boards and the PMS5003 Sensors. its there any published instructions on how to connect these two together. The Enviro+ has a connector already attached while the Enviro board does not. The PMS5003 sensor comes with a cable as well as a small header board, is it as simple as attaching that header board to Enviro's open pins? Thank you.

Posts: 1
Joined: Wed Oct 16, 2013 11:48 pm

Re: Enviro & PMS5003 Part Sensor

by mikeysklar on Tue Nov 30, 2021 6:14 pm

I don't know if the Pimoroni Enviro's can be connected together. This is a good question for Pimoroni since those devices do have i2c pins exposed it seems possible.


Posts: 6526
Joined: Mon Aug 01, 2016 8:10 pm

Please be positive and constructive with your questions and comments.