Hi,
Just about to complete my project, Machine Learning Camera, noticed that the TFT display on the BrainCraft is separating from its backing.
Is there an adhesive there to hold the display in play. Did I miss that. Photo attached,
Appreciate your assistance.
Regards,
Joe
BrainCraft Hat
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- jprema
- Posts: 4
- Joined: Sun Jun 13, 2021 5:50 pm
BrainCraft Hat
- Attachments
-
- BrainCraft Display
- IMG_4124.jpg (634.03 KiB) Viewed 120 times
- mikeysklar
- Posts: 13936
- Joined: Mon Aug 01, 2016 8:10 pm
Re: BrainCraft Hat
This happens with TFTs when they have nothing holding them in place.
T6000 glue or related craft glue on the edges works great. You can also you a clear cover or tape over the LCD to hold it in place.
T6000 glue or related craft glue on the edges works great. You can also you a clear cover or tape over the LCD to hold it in place.
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/