I just installed the Pi eye software o a Pi3B with an Adafruit 5" HDMI display. However, only 2/3rd of the eye is visible (the eye is not centered).
config.txt is set to group = 2 mode=87, cvt = 800 480 60 6 0 0 0 .
Any suggestions to center the eye image?
PI Eye partial eye on HDMI
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- nl28382
- Posts: 56
- Joined: Wed Jan 11, 2017 10:13 am
PI Eye partial eye on HDMI
- Attachments
-
- Photo of display attached
- IMG_4050[1].JPG (274.4 KiB) Viewed 99 times
- nl28382
- Posts: 56
- Joined: Wed Jan 11, 2017 10:13 am
Re: PI Eye partial eye on HDMI
Found the issue.
There was a second section of HDMI config at the bottom of the config.txt file that re-set the HDMI resolution to 640 by 480 under "NOOBS Auto=Generate Setting". I commented this out and now get a centered eye.
There was a second section of HDMI config at the bottom of the config.txt file that re-set the HDMI resolution to 640 by 480 under "NOOBS Auto=Generate Setting". I commented this out and now get a centered eye.
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/