Enviro & PMS5003 Part Sensor
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- worbc
- Posts: 1
- Joined: Wed Oct 16, 2013 11:48 pm
Enviro & PMS5003 Part Sensor
I mistakenly purchased the four Enviro instead of the Enviro+ boards and the PMS5003 Sensors. its there any published instructions on how to connect these two together. The Enviro+ has a connector already attached while the Enviro board does not. The PMS5003 sensor comes with a cable as well as a small header board, is it as simple as attaching that header board to Enviro's open pins? Thank you.
- mikeysklar
- Posts: 14165
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Enviro & PMS5003 Part Sensor
I don't know if the Pimoroni Enviro's can be connected together. This is a good question for Pimoroni since those devices do have i2c pins exposed it seems possible.
http://forums.pimoroni.com/
https://shop.pimoroni.com/pages/contact-us
http://forums.pimoroni.com/
https://shop.pimoroni.com/pages/contact-us
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/