6.5.2022
Hello,
What is the best was to convert 3v3 to 5v and vice-versa for the RPi.
I assume I must use a buffer using its own power supply when converting to 3v3 to 5V - since the current output of the GPIO is rather limited should I want a higher current.
Any tips for me....I would like ideally a built and tested HW??
Many thanks
3v3 to %v and 5V to 3v3 for RPi GPIO
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- adafruit_support_bill
- Posts: 88088
- Joined: Sat Feb 07, 2009 10:11 am
Re: 3v3 to %v and 5V to 3v3 for RPi GPIO
That depends on what you need it for. We have several logic level shifters for various types of signals: https://www.adafruit.com/category/864
And there are voltage boosters and voltage regulators for power applications: https://www.adafruit.com/category/139
And there are voltage boosters and voltage regulators for power applications: https://www.adafruit.com/category/139
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/