Resistance between +5v and ground of 16-Channel PWM/Servo HA
Moderators: adafruit_support_bill, adafruit
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
- m0n0white
- Posts: 2
- Joined: Sat Jun 25, 2022 9:36 am
Resistance between +5v and ground of 16-Channel PWM/Servo HA
The resistance between +5v and ground of 16-Channel PWM/Servo HAT & Bonnet for Raspberry Pi is about 20 Mohm after I soldered the header pins on it. Is the resistance within a normal range? I understand that the short circuit current is very small when the resistance is 20 Mohm. But I just want to make sure everything is ok as I burnt the last board without knowing the reason. Many thanks.
- adafruit_support_bill
- Posts: 88092
- Joined: Sat Feb 07, 2009 10:11 am
Re: Resistance between +5v and ground of 16-Channel PWM/Serv
20 megaohms should not be a problem.
Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/