Raspberry Pi footprints?
Moderators: adafruit_support_bill, adafruit

Forum rules
Talk about Adafruit Raspberry Pi® accessories! Please do not ask for Linux support, this is for Adafruit products only! For Raspberry Pi help please visit: http://www.raspberrypi.org/phpBB3/
Please be positive and constructive with your questions and comments.

Raspberry Pi footprints?

by osbock on Fri Jun 01, 2012 9:49 am

The Wyolum gang (including myself) are working on a 'duino clone/plate for the Raspberry Pi(announcement here: http://baldwisdom.com/raspberry-pi-a-la-mode/)
We don't have a Pi in our hot little hands yet (sigh, ordered back in early march)
and the documentation on the elinux wiki seems inconsistent. When I scale the width of the Gerber png they have up to the specified width, the height doesn't match. Pin spacing seems ok though..
Does anyone have a footprint drawing they can share? We're most concerned about the spacing between the GPIO header and the JTAG header. We're planning on passing through the JTAG both for future debugging and for stability (female header on the bottom of our "plate")
We prefer KiCad, but anything (even a properly scaled jpeg) would do. (scan your pi anyone?)

Posts: 143
Joined: Tue Jan 23, 2007 1:12 pm

Re: Raspberry Pi footprints?

by kphannan on Tue Jun 19, 2012 1:38 pm

I'm looking for the same thing. I am trying to lay out a CAN interface board and need the overall dimensions and placement of the GPIO connector. All the rest of the connectors would be great, but not needed immediately.

Posts: 1
Joined: Fri Aug 19, 2011 9:07 am

Please be positive and constructive with your questions and comments.