Just received my acryclic case order for a Raspberry Pi. It's an ingenious design and looks very cool. The only downside is that once assembled it seems to be quite loose and rattles around when held or moved. Is this by design? I've double checked the side and end plates are facing the correct directions too. I'm wondering if the top/bottom plate side tabs are a just a little too small for the side plates.
Any advice much appreciated,
that's correct, it should hold the pi and also have a little wiggle room. the pi does not have any mounting holes so our design holds it together safe, while still not pressing up against it too much. the pi is stationary product, are you using the case on something that is mobile and moving around a lot?
adafruit support, phil