I left my Hallowing m4 turned on and plugged in to my laptop. It was displaying one of the pre-installed eyes and had absolutely nothing plugged into it but the LiPo I purchased with it.
In the morning the screen was blank and the board seemed non-responsive. One time I plugged it into the laptop and got a beep from the computer indicating an acknowledgement that something was plugged in. After that the board seems dead.
Any chance of a ressurection.
Colin Winterburn
Hallowing
Moderators: adafruit_support_bill, adafruit
4 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.
Double check the power switch and make sure it's on.
What happens if you double press the reset button? Can you get the BOOT folder to show up?
What happens if you double press the reset button? Can you get the BOOT folder to show up?
-
adafruit_support_carter - Posts: 23520
- Joined: Tue Nov 29, 2016 2:45 pm
Spreading the reset button caused no reaction. I even checked in device manager and can't find it. I was wrong about not being detected the PC chimes but that is all.
-
Duffy1963 - Posts: 5
- Joined: Fri Dec 17, 2021 9:47 pm
First word last post, should be "pressing or double pressing"
-
Duffy1963 - Posts: 5
- Joined: Fri Dec 17, 2021 9:47 pm
4 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.