No Serial Port on Arduino IDE for Gemma M0
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- Permian
- Posts: 6
- Joined: Wed Jul 07, 2021 2:11 am
No Serial Port on Arduino IDE for Gemma M0
I just recently got an Adafruit Gemma for a costume project of mine. I was able to download the appropriate software to get Gemma recognized as a board with the Arduino software. Just yesterday when choosing a serial port I saw that /dev/cu.Bluetooth-Incoming-Port (Gemma) was an option (at least I think that's what the port read as) and I could get the simple "Blink" code working. Now I don't see that as an option anymore. I've never used a Gemma before and have a little experience using an arduino uno.
- dastels
- Posts: 15659
- Joined: Tue Oct 20, 2015 3:22 pm
Re: No Serial Port on Arduino IDE for Gemma M0
What happens if you press or double-press the reset button?
Dave
Dave
- Permian
- Posts: 6
- Joined: Wed Jul 07, 2021 2:11 am
Re: No Serial Port on Arduino IDE for Gemma M0
Oh, thank you1 I think I was able to fix the problem. The code can fully upload now but the "simple" code isn't showing up on the Neopixel strip I have it connected to. I made sure to change the data pin in the code to 1. Should I post this question on a separate post?
- dastels
- Posts: 15659
- Joined: Tue Oct 20, 2015 3:22 pm
Re: No Serial Port on Arduino IDE for Gemma M0
Please do. There's a better forum for that having to do with LEDs.
Dave
Dave
Please be positive and constructive with your questions and comments.