0

Mini Spy Cam Wire Question
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Mini Spy Cam Wire Question

by btwebb21 on Mon Oct 08, 2018 11:49 pm

I just received the mini spy cam in the mail, but noticed the white wire isn't fully soldered onto the board. There's two pads that the wire could go to, and I couldn't see close enough on any of the product page pics to figure out where it should go. In one of the photos it looks like the ground/black wire is not attached, but it's the white wire, I was trying to get it from the right angle. See attached photos. Suggestions?
IMG_3703.jpg
White_wire
IMG_3703.jpg (802.28 KiB) Viewed 54 times
IMG_3704.jpg
white_wire
IMG_3704.jpg (739.48 KiB) Viewed 54 times

btwebb21
 
Posts: 1
Joined: Wed Nov 01, 2017 1:07 pm

Re: Mini Spy Cam Wire Question

by Berentis on Wed Oct 10, 2018 10:21 pm

I have the same fear with my camera board. The wires seem almost ready to break off.
On my board, the white wire is next to the black, with an empty solder pad to the other side of the white wire.

I tried taking a photo of the board, but the camera I used wasn't the best. Hope this helps.
image.jpeg
Spy camera board
image.jpeg (91.66 KiB) Viewed 41 times

Berentis
 
Posts: 6
Joined: Fri Feb 17, 2017 4:46 am

Please be positive and constructive with your questions and comments.