Pro Trinket Reprogramming Failure

Adafruit's tiny microcontroller platform. Please tell us which board you are using.
For CircuitPython issues, ask in the Adafruit CircuitPython forum.

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
Dfitterman
 
Posts: 100
Joined: Sat Apr 15, 2017 10:57 am

Pro Trinket Reprogramming Failure

Post by Dfitterman »

I am trying to reprogram a Pro Trinket bootloader because I could never get the flashing red light when the reset button was pushed.

Following the online directions I get the following message when the protrinket5v_bootloader sketch is run.

Code: Select all

Adafruit Trinket 5V programmer - June 9 2015

Type 'G' or hit BUTTON for next chip
Starting Program Mode [OK]

Reading signature:0
  (no target attached?)
Signature fail
What is causing this problem?

User avatar
adafruit_support_carter
 
Posts: 29168
Joined: Tue Nov 29, 2016 2:45 pm

Re: Pro Trinket Reprogramming Failure

Post by adafruit_support_carter »


Locked
Please be positive and constructive with your questions and comments.

Return to “Trinket ATTiny, Trinket M0”