CIRCUITPY not showing up in Windows 10

[Energetix]

I recently purchased a Trinket M0 that's been made into a two-key keyboard (linked below). I'm trying to figure out how to remap the keys into a macro or otherwise map it to a key I don't use often to use a third party macro program. Only problem is I can't even get into the code to try to figure out what I'd have to change in order to get this done. CIRCUITPY does not show up on my device list. Any help is highly appreciated. Thanks.

[Franklin97355]

Only the Express boards show up as drives. You would need to use the Arduino IDE to program the Trinket M0.

[Energetix]

I just figured it out. Thanks very much.