I use Bluefruit LE Sniffer - Bluetooth Low Energy (BLE 4.0), nRF Sniffer V2 BETA 1, python 2.7.15. wireshark 3.2.3.
The sniffer has a red light in MODE.
I followed the instructions in the user guide(https://cdn-learn.adafruit.com/download ... niffer.pdf), but another problem occurred.
I think my problem is that I can't see wireshark interface.
If everything is ok, it should look like this.
But mine looks like this.
I check --device but it says 'An interface must be provided or the selection must be displayed',
I check --extcap-interfaces but there is no interface.
Yeah! The interface is not visible.
In the end, it also appears like this in Wireshark. The interface is not visible too:
I don't know how to make the interface visible.
Bluefruit LE Sniffer Wireshark interface problem
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- dasol0124
- Posts: 2
- Joined: Thu Jun 17, 2021 6:22 am
- mikeysklar
- Posts: 13936
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Bluefruit LE Sniffer Wireshark interface problem
Did you install the driver for the FT231x device on the sniffer?
https://learn.adafruit.com/introducing- ... er-install
That seems like the most likely reason you would not be seeing a usable COM port.
https://learn.adafruit.com/introducing- ... er-install
That seems like the most likely reason you would not be seeing a usable COM port.
Please be positive and constructive with your questions and comments.