Very curious to know if FONA board's ATMEGA32 runs off Microchip's factory settings. I.e. SPI interface was not used to configure the ATMEGA32 fuse bytes before USB functions with the on-board 8 MHZ osc.
If factory settings were changed, is it possible to provide the delta config for the FONA feather board please?
FONA's ATMEGA32, does it use factory fuse settings
Moderators: adafruit_support_bill, adafruit
1 post
• Page 1 of 1
Please be positive and constructive with your questions and comments.
-
hardwareart - Posts: 7
- Joined: Wed Apr 15, 2015 11:40 am
1 post
• Page 1 of 1
Please be positive and constructive with your questions and comments.