I know that a TCA9548A 1-to-8 I2C multiplexer will allow two I2C devices same ID to be addressed. Will using two digital pins as Exclusive OR at 3.3 volt output used to provide alternate Vcc power create the same effect? Then knowing which I2C is being powered, the output can be steered to the appropriate variable without the need for a TCA9548A 1-to-8 I2C multiplexer. Will this work instead of:
REF: https://learn.adafruit.com/adafruit-tca ... r-breakout ??
multiple I2C devices same ID, simple solution??
Moderators: adafruit_support_bill, adafruit
Forum rules
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
If you're posting code, please make sure your code does not include your Adafruit IO Active Key or WiFi network credentials.
2 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.
-
WinniePough - Posts: 1
- Joined: Thu Sep 24, 2015 9:58 pm
Re: multiple I2C devices same ID, simple solution??
No. Turning off VCC turns the pullups into pulldowns, so nothing on the bus will work.
-
adafruit_support_bill - Posts: 79929
- Joined: Sat Feb 07, 2009 10:11 am
2 posts
• Page 1 of 1
Please be positive and constructive with your questions and comments.