I'm busy with a nRF52832 to communicate over BLE Uart with an Android Application.
In the example code of the BLE uart are the following lines:
Code: Select all
// Configure and Start Device Information Service
bledis.setManufacturer("Adafruit Industries");
bledis.setModel("Bluefruit Feather52");
bledis.begin();
When I change these to my own names, it still doesn't change when I tried to connect to the host. I can see the names when I scan the device's.
When looking at BLEDis.cpp there is a define:
Code: Select all
#ifdef USB_PRODUCT
this->setModel(USB_PRODUCT);
#else
this->setModel("Feather nRF52832");
#endif
Also tried then with #define USB_PRODUCT "Own_name" but this is also not working. I'm guessing it is a 'deeper' problem, I don't have a lot of experience with bluetooth. Probably just as many want to send some bytes over....;)