0

Confirmation: Feather NRF52 will work with vibrating disc,
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Confirmation: Feather NRF52 will work with vibrating disc,

by tylersuard on Thu Jun 21, 2018 2:49 pm

I just want to make sure I've got this right.

I have an NRF52 Feather

I have a Myoware muscle sensor connected to it

I want to make a vibration motor run on the same Feather

In order to do that I need to buy the DRV2605L Haptic Motor Controller.

Is that it? Anything else needed? Will the pins needed by the DRV2605L Haptic Motor Controller interfere with the pins needed by the muscle sensor?

Thanks for your help.

tylersuard
 
Posts: 14
Joined: Sun Jun 03, 2018 2:45 pm

Re: Confirmation: Feather NRF52 will work with vibrating di

by adafruit_support_carter on Thu Jun 21, 2018 6:01 pm

You should be OK. The muscle sensor is analog while the motor driver uses I2C. So the muscle sensor's signal wire will go to one of the ADC pins and the motor driver will go to the I2C pins (SCL/SDA).
https://learn.adafruit.com/bluefruit-nr ... ice-pinout

adafruit_support_carter
 
Posts: 5628
Joined: Tue Nov 29, 2016 2:45 pm

Please be positive and constructive with your questions and comments.