0

Help Programming the HUZZAH32
Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.

Help Programming the HUZZAH32

by AwesomeCronk on Thu Jun 13, 2019 3:10 pm

I am trying to program my newly purchased HUZZAH32 Feather using the Arduino IDE. I am using the generic Blink example. The last message I see in the bottom report bar is:
"Hard resetting via RTS pin..."
The red light on the feather, marked "#13", continues to blink, either in a continuous pattern or a pattern of (one two three four five pause. One two three...). The yellow charge light is blinking rapid fire. These lights do this whenever power is available, regardless of programming attempts.

How can this be fixed?

AwesomeCronk
 
Posts: 4
Joined: Fri Jun 07, 2019 9:43 am

Please be positive and constructive with your questions and comments.