Hello.
I wanna use SEGGER J-Link EDU Mini - JTAG/SWD Debugger to program Icarus IoT Board - nRF9160. The connector does not match!
There is a tiny 6pin connector on Icarus IoT Board - nRF9160
There is 2x5 tiny flat cable in SEGGER J-Link EDU Mini - JTAG/SWD Debugger package
Any solution to connect them together?
thanks
Icarus IoT Board - nRF9160 SEGGER J-Link EDU Mini
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- iotai
- Posts: 1
- Joined: Thu Jun 03, 2021 11:43 pm
- mikeysklar
- Posts: 14194
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Icarus IoT Board - nRF9160 SEGGER J-Link EDU Mini
I had to look into this as I had not seen this 6-pin needle programming interface before. I too had been used to the 2x5 the Segger Jlink ships with. I think you will need to purchase the TagConnect 2050 IDC or roll your own. We don't sell this accessory.
https://www.tag-connect.com/product/tc2 ... t-2050-idc
https://www.tag-connect.com/product/tc2 ... t-2050-idc
Please be positive and constructive with your questions and comments.