Part for Eagle
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- flounder
- Posts: 494
- Joined: Wed Sep 18, 2013 9:10 pm
Part for Eagle
I am about to design a custom board into which I will plug a Feather Huzzah (#3405) and a few other parts. I want to lay down sockets for these parts. This means I want a socket template for an ESP32 Feather Huzzah. I don't need the complete board layout, just a "part" which I can drop in the schematic to wire up, and then place it on the PCB. I will solder a socket in, and plug the Huzzah into that socket. Even going to the download section and going to GitHub doesn't help, because I can't figure out what to do next to get a part into Eagle. Some pointers would be useful. I normally use GitHub by way of Eclipse, Visual Studio, or Visual Studio Code, and they handle all the grottiness for me.
- mikeysklar
- Posts: 13936
- Joined: Mon Aug 01, 2016 8:10 pm
Re: Part for Eagle
@flounder,
Have you used Eagle for other PCB designs?
You might find it easier to use Fritzing to import the Huzzah32 for the PCB socket if you are making a basic PCB.
https://github.com/adafruit/Fritzing-Li ... ather.fzpz
Have you used Eagle for other PCB designs?
You might find it easier to use Fritzing to import the Huzzah32 for the PCB socket if you are making a basic PCB.
https://github.com/adafruit/Fritzing-Li ... ather.fzpz
Please be positive and constructive with your questions and comments.