I received the Hallowing in ADABOX009. I plugged in into my Mac and the demo sketch ran fine. I then set up the Arduino IDE and upload the Graphics test code from the Hallowing Overview. This started running, but then stopped. The screen is blank. The reset button does nothing except blink the red light. The Hallowing not longer connects to a port on the Mac. Also tried connecting on a Raspberry Pi. Tried different cables. The Hallowing appears dead. Did I do something to cause this? How do I go about troubleshooting to see if the Hallowing is still OK?
Thanks
Hallowing No Longer Working
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- adafruit_support_carter
- Posts: 29159
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Hallowing No Longer Working
First, let's see if you can get the board into bootloader mode. Try this:
https://learn.adafruit.com/adafruit-hal ... -mode-38-4
and see if you can get the folder HALLOWBOOT to show up.
https://learn.adafruit.com/adafruit-hal ... -mode-38-4
and see if you can get the folder HALLOWBOOT to show up.
- rickbolla
- Posts: 4
- Joined: Sat Oct 25, 2014 3:19 pm
Re: Hallowing No Longer Working
I was able to get the board into bootloader mode and uploaded the Spooky Eye UF2 file. After that, I was able to compile and uploaded sketches to the Hallowing.
- adafruit_support_carter
- Posts: 29159
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Hallowing No Longer Working
There was probably just something wrong with the firmware or the program it was trying to run. If it happens again, this same process can be used to recover.
- keithrule
- Posts: 1
- Joined: Sun Sep 17, 2017 1:49 pm
Re: Hallowing No Longer Working
I'm having similar problem. I can download a sketch but it doesn't appear to run. I've put it in bootloader mode and can load the UF2 files. This gets it back to the moving eye demo. However when I load any sketch (such as full_test), it compiles and downloads but all I get back from the serial monitor is:
Reading Manuf ID
JEDEC ID: 0x0
Manuf: 0x0 Device: 0x0
Any ideas would be appreciated.
Thanks
Reading Manuf ID
JEDEC ID: 0x0
Manuf: 0x0 Device: 0x0
Any ideas would be appreciated.
Thanks
- adafruit_support_carter
- Posts: 29159
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Hallowing No Longer Working
@keithrule Please start a new thread for your issue.
Please be positive and constructive with your questions and comments.