Macropad screen not displaying top two lines

Moderators: adafruit_support_bill, adafruit

Please be positive and constructive with your questions and comments.
Locked
User avatar
PhotoRunner
 
Posts: 3
Joined: Mon Sep 24, 2018 1:44 pm

Macropad screen not displaying top two lines

Post by PhotoRunner »

Hi All!
I am working with a MacroPad from the last Adabox and it doesn't display the top few lines on the screen? There was previously an issue where the screen had a band of corruption, but that has gone away over time.

Any thoughts on how to fix this?
Attachments
MacroPadScreen.png
MacroPadScreen.png (973.3 KiB) Viewed 1407 times

User avatar
adafruit_support_carter
 
Posts: 29056
Joined: Tue Nov 29, 2016 2:45 pm

Re: Macropad screen not displaying top two lines

Post by adafruit_support_carter »

Try downloading this pre-complied demo UF2:
https://learn.adafruit.com/adafruit-mac ... -3100141-2
and running that.

Post a photo of what the OLED looks like running that.

User avatar
PhotoRunner
 
Posts: 3
Joined: Mon Sep 24, 2018 1:44 pm

Re: Macropad screen not displaying top two lines

Post by PhotoRunner »

Apologies for the delay, please see below a photo running the example code and the second is the boot output from a fresh install of CircuitPython 7.0.0
Macorpad1.jpg
Macorpad1.jpg (568.53 KiB) Viewed 1355 times
MacroPad2.jpg
MacroPad2.jpg (556.74 KiB) Viewed 1355 times

User avatar
adafruit_support_carter
 
Posts: 29056
Joined: Tue Nov 29, 2016 2:45 pm

Re: Macropad screen not displaying top two lines

Post by adafruit_support_carter »

It looks like it's working.

In the photos where the lines have been cutoff, the display is just scrolling the output. So those lines have scrolled to the top and only part of the line visible.

Locked
Please be positive and constructive with your questions and comments.

Return to “AdaBox! Show us what you made!”