Hi All!
I am working with a MacroPad from the last Adabox and it doesn't display the top few lines on the screen? There was previously an issue where the screen had a band of corruption, but that has gone away over time.
Any thoughts on how to fix this?
Macropad screen not displaying top two lines
Moderators: adafruit_support_bill, adafruit
Please be positive and constructive with your questions and comments.
- PhotoRunner
- Posts: 3
- Joined: Mon Sep 24, 2018 1:44 pm
Macropad screen not displaying top two lines
- Attachments
-
- MacroPadScreen.png (973.3 KiB) Viewed 1432 times
- adafruit_support_carter
- Posts: 29189
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Macropad screen not displaying top two lines
Try downloading this pre-complied demo UF2:
https://learn.adafruit.com/adafruit-mac ... -3100141-2
and running that.
Post a photo of what the OLED looks like running that.
https://learn.adafruit.com/adafruit-mac ... -3100141-2
and running that.
Post a photo of what the OLED looks like running that.
- PhotoRunner
- Posts: 3
- Joined: Mon Sep 24, 2018 1:44 pm
Re: Macropad screen not displaying top two lines
Apologies for the delay, please see below a photo running the example code and the second is the boot output from a fresh install of CircuitPython 7.0.0
- adafruit_support_carter
- Posts: 29189
- Joined: Tue Nov 29, 2016 2:45 pm
Re: Macropad screen not displaying top two lines
It looks like it's working.
In the photos where the lines have been cutoff, the display is just scrolling the output. So those lines have scrolled to the top and only part of the line visible.
In the photos where the lines have been cutoff, the display is just scrolling the output. So those lines have scrolled to the top and only part of the line visible.
Please be positive and constructive with your questions and comments.